I am not a plumber, but I am familiar with oxidation.  Many simple plumbing valves only need to be removed and new "O" rings installed.  That's where the problem comes in.  Most older homes used metal pipes and not PVC.  Usually the valve screws into a different type of metal and oxidation occurs between the two metals, almost becoming one.  In order to get the valve stem out you have to break it loose.  If you break the pipe, not only do you have a mess but then you have to pay to fix it.  Simple if you break it you pay.  If a plumber breaks it, he is responsible.  I recommend paying the plumbers fee and save yourselves headaches in the long run. 
 James and Paul did an AWESOME job from start to finish with our toilet replacement and installation!! We unfortunately had a bad experience with our general contractor and his plumber and needed immediate assistance. I called Atomic and they immediately got me connected with a scheduler, then had James and Paul out to our house extremely fast! James and Paul were friendly, knowledgeable, professional, and efficient. They advised us based on their expertise and helped us pick out a new toilet and install it correctly. We are so grateful for their work and their professionalism. Would highly recommend them and hire them again! 

Plastic pipe is in wide use for domestic water supply and drain-waste-vent (DWV) pipe. Principal types include: Polyvinyl chloride (PVC) was produced experimentally in the 19th century but did not become practical to manufacture until 1926, when Waldo Semon of BF Goodrich Co. developed a method to plasticize PVC, making it easier to process. PVC pipe began to be manufactured in the 1940s and was in wide use for Drain-Waste-Vent piping during the reconstruction of Germany and Japan following WWII. In the 1950s, plastics manufacturers in Western Europe and Japan began producing acrylonitrile butadiene styrene (ABS) pipe. The method for producing cross-linked polyethylene (PEX) was also developed in the 1950s. Plastic supply pipes have become increasingly common, with a variety of materials and fittings employed.
Most plumbers, pipefitters, and steamfitters learn their trade through a 4- or 5-year apprenticeship. Apprentices typically receive 2,000 hours of paid on-the-job training, as well as some classroom instruction, each year. In the classroom, apprentices learn safety, local plumbing codes and regulations, and blueprint reading. They also study mathematics, applied physics, and chemistry. Apprenticeship programs are offered by unions and businesses. Although most workers enter apprenticeships directly, some start out as helpers. The Home Builders Institute offers a pre-apprenticeship training program in plumbing and other trades.

Plumbing Repair

×